Vinyl -
White Frames for Hurricane Impact Doorglass

RSL Maintenance Free Hurricane Impact frames meet & exceed IBC & IRC requirements for high velocity building materials: Approval #FL 11515. They have chemically welded mitres for strength and durability. They do not require finishing and will retain their original color if unfinished. No primer is needed. If finishing is desired, simply use latex paint, paint labeled “For Plastics” or gel stains followed by two topcoats of clear polyurethane.

Always install frames with screws to the inside of home. Remove tabs from glass; place frame with glass in it on a clean flat assembly table; using tube supplied by RSL neatly apply 3/16" bead of sealant around the perimeter of the frame. Lower door cut-out onto the frame on the table so that it presses down into the silicone; place inside frame into cut-out and snap frame halves together; install provided zinc coated screws into predrilled holes loosely; tighten with maximum 8-10 inch/lbs of torque and do not over tighten; snap (2) short caps on inside frame; install (2) longer caps by bowing them in the middle to complete assembly.

Twenty-year Limited Warranty.

Injection Molded -
White or Tan Frames for Clear, Low E or
GBG Doorglass

RSL Injection Molded Maintenance Free frames do not require finishing and retain their original color if unfinished. If finishing is desired, bothprimers and paints labeled "For Plastics" must beused. For staining, primers are also required and then use gels stains with two coats of clear polyurethane.

Using paint thinners or similar chemicals will void warranty and lose effectiveness of frame to door and frame to glass sealants. Always install frames with screws to the inside of home. Do not over tighten screws (max 18-20 inch/lbs).

Limited Lifetime Warranty.

Injection Molded -
White or Tan Frames for Decorative Doorglass

RSL Injection Molded Maintenance Free Frames do not require finishing and retain their original color if unfinished. If finishing is desired, avoid using primers and apply two coats of exterior latex or polyurethane paint.

For staining, also avoid primers and use gel stains with two coats of clear polyurethane.

Using paint thinners or similar chemicals will void warranty and lose effectiveness of frame to door and frame to glass sealants.

Always install frames with screws to the inside of home. Do not over tighten screws (max 18- 20 inch/lbs).

Interior decorative glass is handcrafted, so bubbles and variations are not defects.

Limited Lifetime Warranty.

Vinyl -
White or Tan Frames for Clear, Low E, GBG,
BBG or Decorative Doorglass

RSL Maintenance Free Vinyl Frames have chemically welded mitres for strength and durability. They do not require finishing and retain their original color if unfinished. If finishing is desired, only use primers and paints labeled “For Plastics.” For staining, use gel stains with two topcoats of clear polyurethane.

RSL white and tan vinyl frames have a soft and flexible gasket for a clean and reliable frame to door and frame to glass seal. Always install frames with screws to the inside of home. Do not over tighten screws (max. 10-12 inch/lbs).

Limited Lifetime Warranty.